Installing The Pcmcia Adapter; Installing The Pcmcia Adapter Drivers - Black Box LW0050A Manual

CHAPTER 4: PCMCIA Adapter Installation, Setup, and Management
• We highly recommend that you remove all PCMCIA cards from the notebook
prior to installing the PCMCIA Adapter. This will help to avoid conflicts
during installation. If you have another network card installed (for example,
an Ethernet card), you must remove it prior to installing the PCMCIA PC Card.

4.3 Installing the PCMCIA Adapter

Installing the PCMCIA Adapter consists of the following installation steps:
• Installing the card in a PCMCIA slot
• Installing the PCMCIA Adapter drivers and utilities
Section 4.3.3 provides instructions on performing initial configuration of the Card.
Section 4.8 provides installation troubleshooting information.
If you are installing the card under Windows 95 or Windows 98, there are
two installation options. You can install the drivers and utilities
separately, or you can use the Upgrade Kit program to install all
components in one session. The Upgrade Kit program is described in
Section 4.7.
4.3.1 I
NSTALLING THE
The PCMCIA Adapter can be installed to operate under a wide range of PC
operating systems. The following table lists the supported operating systems,
together with the section number in this guide which describes the relevant
installation procedure.
If you are installing the
PCMCIA Adapter under:
PCMCIA A
DAPTER
Windows 98
Windows 95A
Windows 95B
Windows NT
ODI (DOS)
NOTE
D
RIVERS
Refer to:
Section 4.3.1.1
Section 4.3.1.2
Section 4.3.1.3
Section 4.3.1.4
Section 4.9
51