2.5 Connect the Unit to the Ethernet Port
• Connect one end of an Ethernet 10BASE-T cable (not supplied) to the RJ-45
port on the rear panel of the unit (marked UTP).
• Connect the other end of the connector cable to the Ethernet outlet:
When connecting a Single-Port Station Adapter or Four-Port Station
Adapter to a PC, use a straight cable.
When connecting an Access Point or Ethernet Workgroup Bridge to a
LAN, use a straight cable.
When connecting an Access Point or Ethernet Workgroup Bridge to a
PC, use a crossed cable.
When connecting an Access Point to a Ethernet Workgroup Bridge, use
a crossed cable.
2.6 Check LED Indicators
Verify that the unit is functioning correctly via the front-panel LEDs. The following
tables describe the front-panel LEDs for Station Adapters, Bridges, and Access
Points.
2.6.1 LED
S
S ON
TATION
Name
Description
PWR
power supply
WLNK WLAN Link
ETHR Ethernet activity
A
B
DAPTERS AND
RIDGES
On – After successful power-up
Off – Power off
On – Unit is synchronized or associated with an
Access Point
Off – Unit is not synchronized or associated with an
Access Point
On – Reception on Ethernet port
Off – No reception on Ethernet port
CHAPTER 2: Basic Installation
Meaning
23