Reach Bee 8 User Manual page 8

REACHBee 8 CL360
User Manual
Table 2-1 Front panel button description
No. Name
LCD
1
screen
Volume
2
Status
3 - 6
indicator
7 REC
PAUSE
8
All Rights Reserved © SZ REACH TECH CO., LTD.
1
Figure 2-1
Displays different status information about Bee 8. For example,
during the starting process of Bee 8, Starting is displayed on the
screen. After the startup, information such as the system version, IP
address, subnet mask, and network gateway is displayed on the
LCD screen in scrolling mode.
Displays the sound volume dynamically.
The higher the volume bar, the louder the sound; the shorter the
volume bar, the smaller the sound.
Displays the status of Bee 8.
Indicators 3 to 5 specify three different signal sources respectively.
The indicator is on when signals are input; the indicator is off when
no signal is input.
Indicator 6 specifies the operation status of Bee 8. When Bee 8
operates normally, indicator 6 blinks; when Bee 8 becomes faulty,
indicator 6 goes off.
Starts a video recording task.
The button is light-off by default. If there is no recording task on Bee
8 or a running recording task is paused, you can press this button to
start recording. The button lights on after being pressed.
Information about the running recording task will be displayed on
the LCD screen in scrolling mode.
Pauses a video recording or VOD playing task.
The button is light-off by default.
If there is a running recording task on Bee 8, you can press this
button to pause the task. The PAUSE button lights on after being
pressed, and the REC button lights off at the same time. To resume
the recording task, press the REC button again.
2 3 4 7 8
5 6 12 11
Description
9 13
10
3