User Group Management - Reach Bee 8 User Manual

REACHBee 8 CL360
User Manual
Note: When granting a user the authorization to add, modify, or delete a module in the
Module Auth page, tick off View to grant the user the authorization to view the
corresponding module. The authorization to add, modify, or delete a module in the
Module Auth page takes effect only after the View authorization is ticked off.
Note: The user group Administrator has the default initialization authorization (view,
modify, delete or download default files), and the user group Default is only granted the
authorization to view default files.
1.
Enter the self-defined username, set and confirm the password, enter the e-mail,
select the user group, and add a remark in the Basic Information page.
2.
Click Operate Auth to enter the operation authorization page.
3.
Tick off the corresponding authorization as needed.
4.
Click Module Auth to enter the module authorization page.
5.
Tick off the corresponding authorization as needed.
6.
Click System Auth to open the system authorization page.
7.
Tick off the corresponding authorization as needed.
8.
Click OK and a dialog box is prompted.
9.
Click OK or wait for three seconds to complete the operation.

9.4.2 User Group Management

Click User Group in the User & Authorization Management menu to open the User
Group page as shown in Figure 9-27.
In this page, you can add, modify, and delete a user group. In addition, you can set the
authorization of the user group.
Adding a user group
1.
Click New in the tool bar of the User Group page to open the New group page as
shown in Figure 9-28.
All Rights Reserved © SZ REACH TECH CO., LTD.
Figure 9-27
69