System Configuration; Network; User - Reach Bee 8 User Manual

REACHBee 8 CL360
User Manual

3.4 System Configuration

Click Administration to display the system configuration page. By default, the Network
tab is displayed as shown in Figure 3-24. The Administration page consists of six tabs,
namely, Network, User, Device Name, FTP Setting, Sys Upgrade, and USB Function.

3.4.1 Network

You can obtain the IP address of Bee 8 automatically by enabling Dynamic Host
Configuration Protocol (DHCP). Alternatively, you can enter the IP address of Bee 8
manually.
1.
Tick off Enable in DHCP to obtain the IP address of Bee 8 automatically.
2.
If Enable is not ticked off, you can input the IP address information of Bee 8 manually
in IP address, Mask, and Gateway.

3.4.2 User

Click User to open the parameter setting page, as shown in Figure 3-25.
All Rights Reserved © SZ REACH TECH CO., LTD.
Figure 3-24
21