System Configuration - Reach Bee7 User Manual

REACH Bee7
l
User Manual
3.3

System Configuration

Click Administration to display the system configuration page. By default, the
Network tab is displayed as shown in Figure 3-9. The Administration page consists
of three tabs, namely, Network, User, and System Upgrade.
3.3.1 Network
You can obtain the IP address of Bee 7 automatically by enabling Dynamic Host
Configuration Protocol (DHCP). Alternatively, you can enter the IP address of Bee 7
manually.
 Tick off Enable in DHCP to obtain the IP address of Bee 7 automatically. Bee 7
will reboot automatically after the setting, and you can view the IP address
obtained automatically in the LCD screen.
 If Enable is not ticked off, you can fill the IP address information of Bee 7
manually in IP address, Mask, and Gateway. Bee 7 will reboot automatically
after the setting, and you can view the configured IP address in the LCD screen.
3.3.2 User
Click User to open the parameter setting page, as shown in Figure 3-10.
F i gu r e 3 - 9
All Rights Reserved © SZ REACH TECH CO., LTD. 17