Step 13: Install The Operating System Driver; Summary - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

6.2.13 Step 13: Install the Operating System Driver

6.3

Summary

MegaRAID can operate under MS-DOS or any DOS-compatible
operating system using the standard AT BIOS INT 13h Hard Disk Drive
interface. To operate with other operating systems, you must install
software drivers. MegaRAID provides software drivers on the Driver and
Documentation CD for the following operating systems:
MS-DOS version 6.xx or later
Microsoft Windows NT 4.0, Windows 2000, Windows XP, Windows
.NET
Novell NetWare 5.1, 6.0
Red Hat Linux 7.2, 7.3
Note: Refer to the MegaRAID Driver Installation Guide for the
procedures used to install operating system drivers.
This chapter discussed hardware installation. Configure the RAID system
using software configuration utilities. See the MegaRAID Configuration
Software Guide for all information about MegaRAID SCSI 320-2 software
utilities. Table 6.9 lists these utility programs.
Table 6.9 Configuration Utilities and Operating Systems
Configuration Utility
MegaRAID BIOS Configuration Utility
WebBIOS Configuration Utility
MegaRAID Manager
Power Console Plus
Summary
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Operating System
Independent of the operating system
Independent of the operating system
DOS
Red Hat Linux 7.2, 7.3
Novell NetWare 5.1, 6.0
Microsoft Windows NT
Windows 2000
Windows XP
Windows .NET
6-21