Optional Equipment; Installation Steps - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

6.1.1

Optional Equipment

6.2

Installation Steps

6-2
You may also want to install SCSI cables that interconnect the
MegaRAID SCSI 320-2 to external SCSI devices.
The MegaRAID SCSI 320-2 provides extensive customization options. If
you need only basic MegaRAID SCSI 320-2 features and your computer
does not use other adapter cards with resource settings that may conflict
with MegaRAID SCSI 320-2 settings, even custom installation can be
quick and easy.
Table 6.1 lists the hardware installation steps. Each step is described in
detail in the following pages.
Table 6.1 Hardware Installation Steps
Step Action
1 Unpack the MegaRAID controller and
inspect for damage. Make sure all items
are in the package.
2 Turn the computer off and remove the
power cord, and remove the cover.
3 Install cache memory on the MegaRAID
card.
4 Check the jumper settings on the
MegaRAID SCSI 320-2 controller.
5 Set SCSI termination.
6 Set SCSI terminator power (TermPWR).
7 Connect the battery harness.
8 Install the MegaRAID SCSI 320-2 card.
9 Connect the SCSI cables to SCSI devices.
10 Set the target IDs for the SCSI devices.
Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Additional Information
If damaged, call your LSI
Logic OEM support
representative.
32 Mbytes minimum cache
memory is required.
See page 6-5 for the
MegaRAID SCSI 320-2
jumper settings.
Optional