Validating The Cluster Installation; Configuring The Second Node - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

7.4.16 Validating the Cluster Installation

7.4.17 Configuring the Second Node
11. When a dialog box appears telling you that Cluster Service has
started successfully. Click on OK.
12. Close the Add/Remove Programs window.
Use the Cluster Administrator snap-in to validate the Cluster Service
installation on the first node. Follow these steps to validate the cluster
installation.
1. Click on Start.
2. Click on Programs.
3. Click on Administrative Tools.
4. Click on Cluster Administrator.
The Cluster Administrator screen displays. If your snap-in window is
similar to the one shown in the screen, your Cluster Service was
successfully installed on the first node. You are now ready to install
Cluster Service on the second node.
Note: For this procedure, have node one and all shared disks
powered on, then power up the second node.
Cluster Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
7-25