Table of Contents
Advertisement
2. Click on Next in the Configure Cluster Networks dialog box.
3. Verify that the network name and IP address correspond to the
network interface for the public network.
4. Check the box Enable this network for cluster use.
5. Select the option All communications (mixed network), as shown
below, and click on Next.
The next dialog box configures the private network. Make sure that
the network name and IP address correspond to the network
interface used for the private network.
6. Check the box Enable this network for cluster use.
7. Select the option Internal cluster communications only, then click
on Next.
Cluster Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
7-21
Advertisement
Table of Contents
Troubleshooting
