Bios Boot Error Messages - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

8.2

BIOS Boot Error Messages

Table 8.2 BIOS Boot Error Messages
Message
Adapter BIOS Disabled.
No Logical Drives
Handled by BIOS
Host Adapter at
Baseport xxxx Not
Responding
No MegaRAID SCSI
320-2 Adapter
Configuration of
nonvolatile RAM
(NVRAM) and drives
mismatch.
Run View/Add
Configuration option of
Configuration Utility.
Press any key to run the
Configuration Utility.
1 Logical Drive Failed
Table 8.2 describes BIOS error messages that can display when you
boot the system, and suggested solutions.
Problem
The MegaRAID BIOS is
disabled. Sometimes the
BIOS is disabled to
prevent booting from the
BIOS.
The BIOS cannot
communicate with the
adapter firmware.
The BIOS cannot
communicate with the
adapter firmware.
The configuration stored
in the MegaRAID SCSI
320-2 adapter does not
match the configuration
stored in the drives.
A logical drive failed to
sign on.
BIOS Boot Error Messages
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Suggested Solution
Enable the BIOS using the MegaRAID BIOS
Configuration Utility.
Make sure the MegaRAID SCSI 320-2 is
properly installed.
Try moving the MegaRAID controller to another
slot.
Run the MegaRAID Manager Diagnostics to
verify that the MegaRAID controller is
functioning properly
Make sure the MegaRAID SCSI 320-2 is
properly installed.
Try moving the MegaRAID card to another PCI
slot.
Run the MegaRAID Manager Diagnostics to
verify that MegaRAID is functioning properly.
1. Press a key to run MegaRAID Manager.
2. Select View/Add Configuration from the
Configure menu.
3. Use View/Add Configuration to examine
both the configuration in NVRAM and the
configuration stored on the disk drives.
4. Resolve the problem by selecting one of the
configurations.
Make sure all physical drives are properly
connected and are powered on.
Run MegaRAID Manager to find out if any
physical drives are not responding. Reconnect,
replace, or rebuild any drive that is not
responding.
8-3