Network Requirements - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

7.3.2

Network Requirements

7-4
5. Repeat step 1 –
system.
After the cluster is installed, and both nodes are in the Microsoft
Windows 2000 Advanced Server, installation will detect a SCSI
processor device.
6. On the Found New Hardware Wizard prompt, choose to display a list
of the known drivers, so that you can select a specific driver.
7. Click on Next.
8. Select the driver that you want to install for the device. If you have a
disk with the driver you want to install, click on Have Disk.
9. Select Other devices from the list of hardware types, then click on
Next.
10. Insert the disk containing the driver into the selected drive and click
on OK.
11. Select the processor device and click on Next.
12. On the final screen, click on Finish to complete the installation.
13. Repeat the process on the peer system.
The network requirements for clustering are:
A unique NetBIOS cluster name
Five unique, static IP addresses:
– Two addresses are for the network adapters on the internal
network
– Two addresses are for the network adapters on the external
network
– One address is for the cluster itself
A domain user account for Cluster Service (all nodes must be part
of the same domain.)
Two network adapters for each node—one for connection to the
external network and the other for the node-to-node internal cluster
network. If you do not use two network adapters for each node, your
Installing and Configuring Clusters
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
step 4 to install the device driver on the second