J4
J5
J17
External
Very-High
Density
SCSI
J18
Connectors
6.2.4.1
J2 SCSI Activity LED
6.2.4.2
J3 Dirty Cache LED
6.2.4.3
J4/J5 Termination Enable
6-6
Figure 6.2
MegaRAID SCSI 320-2 Controller Layout
Internal High-Density
SCSI Connectors
Channel 0
J2 is a four-pin connector that attaches to a cable that connects to the
hard disk LED mounted on the computer enclosure. The LED indicates
data transfers (SCSI bus activity.)
J3 is a two-pin header for the dirty cache LED. This can be connected
to an LED on the computer enclosure. The LED will be lit when data in
the cache has not yet been written to the storage device.
J4 and J5 are three-pin headers that specify the type of SCSI termination
for channel 0 and channel 1, respectively.
Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Channel 1
DIMM Socket
J2
J3
J10
J16
Table 6.3
shows the jumper