Step 4: Check Jumper Settings - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

6.2.3.2 Recommended Memory Vendors
6.2.4

Step 4: Check Jumper Settings

6. You can now add or remove DRAM modules from the MegaRAID
controller, as described above.
7. Reattach the battery pack harness to J10 on the MegaRAID
controller.
8. Reinstall the MegaRAID controller in the computer. Follow the
instructions in this chapter.
9. Replace the computer cover and turn the computer power on.
Call LSI Logic Technical Support at 678-728-1250 for a current list of
recommended memory vendors.
Make sure the jumper settings on the MegaRAID SCSI 320-2 card are
correct. The jumpers are set at the factory and you probably do not need
to change them. Table 6.2
Table 6.2 Jumpers for the MegaRAID SCSI 320-2
Item Description
J2 SCSI activity LED connector
J3 Write pending indicator
J4 SCSI Termination Enable Channel 0
J5 SCSI Termination Enable Channel 1
J10 Battery connector
J16 BIOS Enable
J17 Termination Power Channel 0
J18 Termination Power Channel 1
Figure 6.2 shows the location of these items on the MegaRAID SCSI
320-2 controller.
Installation Steps
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
lists the jumpers that you should check.
Type
4-pin header
2-pin header
3-pin header
3-pin header
3-pin header
2-pin header
2-pin header
2-pin header
6-5