LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual page 100

Table 7.1 Nodes and Storage Devices
Step
Set Up Networks
Set up Shared Disks
Verify Disk Configuration
Configure the First Node
Configure the Second
Node
Post-installation
7-6
Table 7.1 shows which nodes and storage devices should be powered on
during each step.
Node 1 Node 2 Storage
On On
On Off
Off On
On Off
On On
On On
Before installing the Cluster Service software you must follow the steps
below:
Install Windows 2000 Advanced Server or Windows 2000 Datacenter
Server on each node
Set up networks
Set up disks
Note: These steps must be completed on every cluster node
before proceeding with the installation of Cluster Service on
the first node.
To configure the Cluster Service on a Windows 2000-based server, you
must be able to log on as administrator or have administrative
permissions on each node. Each node must be a member server, or
must be a domain controller inside the same domain. A mix of domain
controllers and member servers in a cluster is not acceptable.
Installing and Configuring Clusters
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Comments
Off Make sure that power to all storage devices
on the shared bus is turned off. Power on
all nodes.
On Power down all nodes. Next, power on the
shared storage, then power on the first
node.
On Shut down the first node. Power on the
second node.
On Shut down all nodes. Power on the first
node.
On Power on the second node after the first
node was successfully configured.
On All nodes should be active.