Verifying Connectivity And Name Resolution - LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Hardware Manual

7.4.7

Verifying Connectivity and Name Resolution

Perform the following steps to verify that the network adapters are
working properly:
Note: Before proceeding, you must know the IP address for each
network card adapter in the cluster. You can obtain it by
using the IPCONFIG command on each node.
1. Click on Start.
2. Click on Run.
3. Type cmd in the text box.
4. Click on OK.
5. Type ipconfig /all and press Enter. IP information displays for all
network adapters in the machine.
6. If you do not already have the command prompt on your screen, click
on Start.
7. Click on Run.
8. In the text box, type:
cmd
9. Click on OK.
10. Type
ping ipaddress
where ipaddress is the IP address for the corresponding network
adapter in the other node. For example, assume that the IP
addresses are set as follows:
Node Network Name
1 Public Cluster Connection
1 Private Cluster Connection
2 Public Cluster Connection
2 Private Cluster Connection
In this example, you would type:
Cluster Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Network Adapter IP Address
192.168.0.171
10.1.1.1
192.168.0.172
10.1.1.2
7-11