Sierra Wireless Clear Spot 4G+ User Manual page 90

Clear Spot 4G+ User Guide
90
Before you can use or configure DMZ, you must enable it.
Enabling DMZ
Before you can use or configure DMZ, you must enable it.
1. Log in to the home page.
Advanced settings
2. Click
Router > Basic
3. Click .
DMZ
4. Next to , select
Save
5. Click .
Configuring DMZ
To configure DMZ:
1. Ensure you've enabled DMZ. See
2. Display the DMZ panel of the Router tab.
a. Log in to the home page.
Advanced settings
b. Click
Router > DMZ
c. Click
3. Specify the computer that you want exposed to the Internet: in the
IP Address
field, enter the IP address of the computer.
If you don't know how to find the IP address, see
page 103.
Source IP Address
4. In the
port forwarding, port triggering, or NAT) to forward to this computer.
To forward all incoming traffic, click
— or —
To forward incoming traffic from certain IP addresses:
Restriction
a. Click
b. In the two additional fields that are displayed, enter the start and end
IP addresses of a range.
5. Using the DHCP Static IP Assignment List, assign an IP address based on
the MAC address of the computer that is in the DMZ. See
IP Address Based on a MAC Address" on page
— or —
On the computer that is in the DMZ, disable DHCP, and manually assign the
IP address, gateway, and DNS server.
( ).
Enable
.
"Enabling DMZ" on page
( ).
.
section, specify what incoming traffic (not handled by
Any
.
.
90.
Destination
"Finding the IP Address" on
"Assigning an
85.
2131352