Table of Contents
Advertisement
Clear Spot 4G+ User Guide
82
Note: If UPnP is enabled, there are potential security risks.
Enabling UPnP
Before you can use UpnP, you must enable it.
1. Log in to the home page.
Advanced settings
2. Click
Router > Basic
3. Click
.
UPnP
4. Next to
, select
SPI (Stateful Packet Inspection)
SPI, also known as "dynamic packet filtering," helps to prevent cyberattacks by
validating that the traffic passing through a session conforms to the protocol used
for this type of session. Packets that are not conforming get rejected.
Enabling SPI
Before you can use SPI, you must enable it.
1. Log in to the home page.
Advanced settings
2. Click
Router > Basic
3. Click
.
SPI
Enable
4. Next to
, select
LAN Panel
1. Log in to the home page.
Advanced settings
2. Click
Router > LAN
3. Click
.
From this window, you can view and adjust settings, or perform the following
actions:
Router IP Address
•
(on the LAN).
Subnet Mask
•
The routing hardware's internal LAN subnet mask.
•
Hostname (Device name). See
"Displaying the Home Page of the Device"
SSID
•
(Wi-Fi network name). See
Link SSID and Hostname
•
page
73.
DHCP Server
•
(enable DHCP)
Note: The following items are displayed only when DHCP is enabled.
DHCP IP Address Range
•
(
).
Enable
.
(
).
.
(
).
"Host Name (Device Name)" on page 78
on page 34.
"SSID (Wi-Fi Network Name)" on page
. See
"Linking the SSID and the Host Name" on
and
72.
2131352
Advertisement
Table of Contents
