ZyXEL Communications ZyWall 110 User Manual page 362

Security firewalls

Hide thumbs Also See for ZyWall 110:

Table of Contents

Figure 245 Configuration > Security Policy > Policy Control > Add

The following table describes the labels in this screen.

Table 151 Configuration > Security Policy > Policy Control > Add

Use to configure any new settings objects that you need to use in this screen.

Select this check box to activate the Security policy.

Type a name to identify the policy

Enter a descriptive name of up to 60 printable ASCII characters for the Policy. Spaces are

For through-ZyWALL/USG policies, select the direction of travel of packets to which the

policy applies.

any means all interfaces.

Device means packets destined for the ZyWALL/USG itself.

Select an IPv4 / IPv6 address or address group object to apply the policy to traffic coming

from it. Select any to apply the policy to all traffic coming from IPv4 / IPv6 addresses.

Select an IPv4 / IPv6 address or address group to apply the policy to traffic going to it.

Select any to apply the policy to all traffic going to IPv4 / IPv6 addresses.

Select a service or service group from the drop-down list box.

Chapter 21 Security Policy

ZyWALL/USG Series User's Guide

Show Quick Links

Table of Contents

Troubleshooting