Log Setting Screens - ZyXEL Communications ZyWall 110 User Manual

The following table describes the labels in this screen.
Table 322 Configuration > Log & Report > Email Daily Report
LABEL
Enable Email
Daily Report
Mail Server
Mail Server Port
TLS Security
Authenticate
Server
Mail Subject
Append
system name
Append date
time
Mail From
Mail To
SMTP
Authentication
User Name
Password
Retype to
Confirm
Send Report Now
Time for sending
report
Report Items
Reset All
Counters
Apply
Reset

37.3 Log Setting Screens

The Log Setting screens control log messages and alerts. A log message stores the information for
viewing or regular e-mailing later, and an alert is e-mailed immediately. Usually, alerts are used for
events that require more serious attention, such as system errors and attacks.
The ZyWALL/USG provides a system log and supports e-mail profiles and remote syslog servers.
View the system log in the MONITOR > Log screen. Use the e-mail profiles to mail log messages
Chapter 37 Log and Report
DESCRIPTION
Select this to send reports by e-mail every day.
Type the name or IP address of the outgoing SMTP server.
Enter the same port number here as is on the mail server for mail traffic.
Select Transport Layer Security (TLS) if you want encrypted communications between the
mail server and the ZyWALL/USG.
If you choose TLS Security, you may also select this to have the ZyWALL/USG
authenticate the mail server in the TLS handshake.
Type the subject line for outgoing e-mail from the ZyWALL/USG.
Select Append system name to add the ZyWALL/USG's system name to the subject.
Select Append date time to add the ZyWALL/USG's system date and time to the subject.
Type the e-mail address from which the outgoing e-mail is delivered. This address is used
in replies.
Type the e-mail address (or addresses) to which the outgoing e-mail is delivered.
Select this check box if it is necessary to provide a user name and password to the SMTP
server.
This box is effective when you select the SMTP Authentication check box. Type the user
name to provide to the SMTP server when the log is e-mailed.
This box is effective when you select the SMTP Authentication check box. Type the
password to provide to the SMTP server when the log is e-mailed.
Type the password again to make sure that you have entered is correctly.
Click this button to have the ZyWALL/USG send the daily e-mail report immediately.
Select the time of day (hours and minutes) when the log is e-mailed. Use 24-hour
notation.
Select the information to include in the report. Types of information include System
Resource Usage, Wireless Report, Threat Report, and Interface Traffic Statistics.
Select Reset counters after sending report successfully if you only want to see
statistics for a 24 hour period.
Click this to discard all report data and start all of the counters over at zero.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
710