Default Zones, Interfaces, And Ports - ZyXEL Communications ZyWall 110 User Manual

Figure 38 USG40 / USG40W Rear Panel
Figure 39 USG60 / USG60W Rear Panel
The following table describes the items on the rear panel
Table 12 Rear Panel Items
LABEL
Console
CF Card Slot
Power
Lock
Fan
Note: Use an 8-wire Ethernet cable to run your Gigabit Ethernet connection at 1000
Mbps. Using a 4-wire Ethernet cable limits your connection to 100 Mbps. Note that
the connection speed also depends on what the Ethernet device at the other end
can support.

3.1.3 Default Zones, Interfaces, and Ports

The default configurations for zones, interfaces, and ports are as follows. References to interfaces
may be generic rather than the specific name used in your model. For example, this guide may use
"the WAN interface" rather than "wan1" or "wan2", "ge2" or" ge3".
An OPT (optional) Ethernet port can be configured as an additional WAN port, LAN, WLAN, or DMZ
port.
Chapter 3 Hardware, Interfaces and Zones
DESCRIPTION
You can use the console port to manage the ZyWALL/USG using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
• Parity None
• Stop Bit 1
• Flow Control Off
Insert a compact flash card into this slot to store ZyWALL/USG system logs. This feature is
not available at the time of writing.
Use the included power cord to connect the power socket to a power outlet. Turn the power
switch on if your ZyWALL/USG has a power switch.
Attach a lock-and-cable from the Kensington lock (the small, metal-reinforced, oval hole)
to a permanent object, such as a pole, to secure the ZyWALL/USG in place.
The fans are for cooling the ZyWALL/USG. Make sure they are not obstructed to allow
maximum ventilation.
ZyWALL/USG Series User's Guide
52