Rear Panels - ZyXEL Communications ZyWall 110 User Manual

Figure 35 USG60 / USG60W Front Panel
The following table describes the LEDs.
Table 11 LED Descriptions
LED COLOR STATUS
PWR
Green
Red
SYS Green
Red
USB Green
Orange
P1, P2... Green
Orange

3.1.2 Rear Panels

The connection ports are located on the rear panel.
Figure 36 ZyWALL 110 / USG110 / USG210 Rear Panel
Figure 37 ZyWALL 310 / ZyWALL 1100 / USG310 / USG1100 / USG1900 Rear Panel
Chapter 3 Hardware, Interfaces and Zones
DESCRIPTION
Off The ZyWALL/USG is turned off.
On The ZyWALL/USG is turned on.
On There is a hardware component failure. Shut down the device, wait for a few
minutes and then restart the device (see
turns red again, then please contact your vendor.
Off The ZyWALL/USG is not ready or has failed.
On The ZyWALL/USG is ready and running.
Blinking The ZyWALL/USG is booting.
On The ZyWALL/USG xd an error or has failed.
Off No device is connected to the ZyWALL/USG's USB port or the connected
device is not supported by the ZyWALL/USG.
On A mobile broadband USB card or USB storage device is connected to the USB
port.
On Connected to a mobile broadband network through the connected mobile
broadband USB card.
Off There is no traffic on this port.
Blinking The ZyWALL/USG is sending or receiving packets on this port.
Off There is no connection on this port.
On This port has a successful link.
ZyWALL/USG Series User's Guide
51
Section 3.2 on page 54). If the LED