ZyXEL Communications ZyWall 110 User Manual page 269

Security firewalls

Hide thumbs Also See for ZyWall 110:

Table of Contents

Figure 183 Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)

The following table describes the labels in this screen.

Table 114 Configuration > Network > Routing > Policy Route > Add/Edit

Show Advanced

Click this button to display a greater or lesser number of configuration fields.

Settings / Hide

Advanced Settings

Create new Object

Use this to configure any new settings objects that you need to use in this screen.

Configuration

Select this to activate the policy.

Enter a descriptive name of up to 31 printable ASCII characters for the policy.

Select a user name or user group from which the packets are sent.

Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or

the ZyWALL/USG itself. For an interface, a tunnel, or an SSL VPN, you also need to

select the individual interface, VPN tunnel, or SSL VPN connection.

Source Address

Select a source IP address object from which the packets are sent.

Destination Address

Select a destination IP address object to which the traffic is being sent. If the next hop

is a dynamic VPN tunnel and you enable Auto Destination Address, the ZyWALL/

USG uses the local network of the peer router that initiated an incoming dynamic IPSec

tunnel as the destination address of the policy instead of your configuration here.

Chapter 10 Routing

ZyWALL/USG Series User's Guide

Show Quick Links

Table of Contents

Troubleshooting