ZyXEL Communications ZyWall 110 User Manual page 647

Figure 438 Configuration > Object > ISP Account > Edit
The following table describes the labels in this screen.
Table 288 Configuration > Object > ISP Account > Edit
LABEL DESCRIPTION
Profile Name This field is read-only if you are editing an existing account. Type in the profile name of the
ISP account. The profile name is used to refer to the ISP account. You may use 1-31
alphanumeric characters, underscores(
a number. This value is case-sensitive.
Protocol This field is read-only if you are editing an existing account. Select the protocol used by
the ISP account. Options are:
pppoe - This ISP account uses the PPPoE protocol.
pptp - This ISP account uses the PPTP protocol.
Authentication Use the drop-down list box to select an authentication protocol for outgoing calls. Options
Type are:
CHAP/PAP - Your ZyWALL/USG accepts either CHAP or PAP when requested by this
remote node.
Chap - Your ZyWALL/USG accepts CHAP only.
PAP - Your ZyWALL/USG accepts PAP only.
MSCHAP - Your ZyWALL/USG accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL/USG accepts MSCHAP-V2 only.
Encryption This field is available if this ISP account uses the PPTP protocol. Use the drop-down list
Method box to select the type of Microsoft Point-to-Point Encryption (MPPE). Options are:
nomppe - This ISP account does not use MPPE.
mppe-40 - This ISP account uses 40-bit MPPE.
mppe-128 - This ISP account uses 128-bit MMPE.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above. The password can only consist of
alphanumeric characters (A-Z, a-z, 0-9). This field can be blank.
Retype to Type your password again to make sure that you have entered is correctly.
Confirm
Server IP If this ISP account uses the PPPoE protocol, this field is not displayed.
If this ISP account uses the PPTP protocol, type the IP address of the PPTP server.
Chapter 35 Object
ZyWALL/USG Series User's Guide
647
), or dashes (-), but the first character cannot be
_