HEATER AND REFRIGERANT SYSTEM
Disassembly note
Shaft seal and seal plate
1. Remove the armature plate.
2. Remove the felt seal and snap ring.
3. Remove the shim(s).
4. Align the cutout of the SST with the groove of the shaft
seal plate and insert the SST into the compressor.
5. Rotate the SST counterclockwise to make sure that the
cutout is engaged with the plate.
6. Pull out the shaft seal plate.
7. Align the cutout of the SST with the metal pawl of the
shaft seal and insert the SST into the compressor.
8. Rotate the SST counterclockwise to make sure that the
cutout is engaged with the metal pawl.
9. Pull out the shaft seal.
G -5 3