Mazda 1996 626 Service Manual page 439

M1
M 1 -1 0
INNER SLIDING SUNROOF
SUNROOF RELAY
Inspection
. Disconnect the sunroof relay connector.
1
2. Apply battery positive voltage and check for continuity
between the relay terminals.
Connection
B+
GND
—
_
B A
3. If not as specified, replace the sunroof relay.
SUNROOF MOTOR ASSEMBLY
Inspection
Motor
1. Disconnect the sunroof motor assembly connector.
2. Connect battery positive voltage to terminal A and
ground to terminal B. Verify that the motor operates.
3. Reverse the above connections and verify that the
motor rotates in the opposite direction.
4. If not as specified, replace the sunroof motor assembly.
Limit switch
1. Disconnect the sunroof motor assembly connector.
2. Move the slide panel to the following positions by using
a screwdriver and check for continuity between the
motor terminals.
3. If not as specified, replace the sliding sunroof motor
assembly.
SUNROOF SWITCH (WITHIN OVERHEAD CONSOLE)
Inspection
1. Remove the overhead console.
(Refer to page M1-11.)
. Check for continuity between the switch terminals.
2
3. If not as specified, replace the overhead console.
0 - 0 : Continuity B+: Battery positive voltage
A B
c
r \ KJ
KJ
-----LJ —
Q _
F
E
0 - 0 : Continuity
0 - 0 : Continuity