I
E
F
G -2 2
TROUBLESHOOTING GUIDE
Step 2
1. Remove the A/C relay.
2. Turn the ignition switch to ON.
3. Measure the voltage at the following terminal wires of
the A/C relay connector.
Wire
(L)
(G/W)
Terminal E
Step 3
n .
1. Connect battery positive voltage and check for continu
c
A
ity between the terminals of the A/C relay.
D
B
B+
—
2. If correct, reinstall the A/C relay and go to Step 4.
3. If not as specified, replace the A/C relay.
Step 4
1. Remove the front console.
(Refer to the 1996 626/MX-6 Workshop Manual, section S.)
2. Disconnect the appropriate PCM (ECM: MIX) connector.
3. Connect a jumper wire between the terminal wire (G/W)
of the A/C relay connector and ground.
4. Turn the ignition switch to ON, and verify that the mag
netic clutch and condenser fan operate.
Magnetic clutch and
condenser fan
Operate
Do not operate
Step 5
1. Turn the A/C switch on and set the fan switch to the first
position.
2. Verify that the A/C switch indicator light illuminates.
Illuminates
Does not illuminate
Voltage
B+
Measure voltage at (G/W) wire
Other
Repair wiring harness
(A/C relay— WIPER 20 A fuse)
B+
Go to Step 3
Other
Repair wiring harness
(A/C relay— AIR-COND 30 A fuse)
0 - 0 : Continuity
0 * K ~ 0 : Diode B+: Battery positive voltage
Connection
GND
D
—
f e A
i
1 U !
U
P
D
A
Transaxle
MTX
ATX
Remove jumper wire, reconnect PCM
(ECM: MTX) connector, and go to Step 5
Repair wiring harness
(A/C relay— Magnetic clutch, condenser fan)
Indicator light
Go to Step 6
Inspect heater control unit
(Refer to page G-^43)
B+: Battery positive voltage
Action
Terminal
E
A
B
C
•hO
0 - 1
k
n
— o
o —
Connector
22-pin
60-pin
Action
Action
F
r
-s