Mazda 1996 626 Service Manual page 109

WARNING SYSTEM
BRAKE FLUID LEVEL SENSOR
Inspection
1. Disconnect the brake fluid level sensor connector.
2. Check for continuity between the sensor terminals.
Fluid level
Below MIN
Above MIN
3. If not as specified, replace the brake fluid level sensor.
(Refer to the 1996 626/MX-6 Workshop Manual, section P.)
OIL PRESSURE SWITCH
Inspection
1. Disconnect the oil pressure switch connector.
2. Check for continuity between the oil pressure switch
terminal and ground.
Engine condition
Stopped
Running
3. If not as specified, replace the oil pressure switch.
(Refer to the 1996 626/MX-6 Workshop Manual, section D.)
WASHER FLUID-LEVEL SENSOR
Inspection
1. Disconnect the washer fluid-level sensor connector.
2. Check for continuity between terminals C and D of the
sensor as shown.
Fluid level
Below MIN
Above MIN
3. If not as specified, replace the washer fluid-level sen­
sor.
C2
Continuity
Yes
No
Continuity
Yes
No
Continuity
Yes
No
C2-33