COMPONENTS
Removal I Installation
1. Raise the rear edge of the door glass about 80 mm {3.2 in} from the fully lowered position.
2. Disconnect the negative battery cable.
Note
• Remove the door screen carefully so that it may be reused.
3. Remove in the order shown in the figure. (Refer to the 1996 626/MX-6 Workshop Manual, section S,
when removing the front door trim.)
4. Install in the reverse order of removal.
626 (FRONT DOOR)
1. Recess cover
2. Inner handle
3. Front door trim
4. Power window main
switch assembly
Inspection
page K1-17
POWER WINDOW SYSTEM
DRIVER'S DOOR
5. Power window subswitch
Inspection.....page K1-18
. Bracket
6
7. Sealing pad
. Door screen
8
PASSENGER S DOOR
9. Front door glass
10. Power window regulator
K1
N m {kgf cm, in lbl}
Inspection..... page K1-18
K 1 -1 9