Mazda 1996 626 Service Manual page 473

Q
VEIHCLL ENGINE SFIFC HON
A
DIAGNOSTIC DATA LINK
VIEW RECORDER AREAS
DIGITAL MEASUREMENT SYSTEM
GENERIC OBDII FUNCTIONS
NO VEHICLE SELECTED
DESELECT CURRENT
c r u is e cunmoi sn> list
CRUISE CONTROL INPUT SW SELF TEST
Q -1 0
CRUISE CONTROL SYSTEM
1. Connect the SST (NGS) to the data link connector and
. Set the SST (Super MECS Adapter) to AUX
2
3. Select "VEHICLE & ENGINE SELECTION" on the SST
MODEL
4. Select "DIAGNOSTIC DATA LINK" on the SST (Control
5 .Select "CCM-CRUISE CONTROL MODULE" on the
. Select "CRUISE CONTROL SELF TEST" on the SST
6
7. (
. After the problems are corrected, repeat the condition
8
Canceling condition detection mode
To cancel condition detection mode, do any one of the fol­
lowing:
• Turn off the cruise control main switch.
• Turn the ignition switch to LOCK.
battery.
(Control Unit) display, and then select the vehicle
model, engine type, and model year.
Unit) display.
SST (Control Unit) display, and then select the "DIAG­
NOSTIC TEST MODE".
(Control Unit) display.
) If a diagnostic trouble code is displayed, refer to the
1
diagnostic trouble code table (Refer to page Q-11)
and inspect the appropriate system area.
(2) If "NO CODES RECEIVED" is displayed, the system
areas shown in the diagnostic trouble code table are
OK. Inspect another system area.
detection mode procedure to verify that the system is
operating normally.
.
2