Water Temperature Sender Unit C1-19; Fuel Gauge Sender Unit - Mazda 1996 626 Service Manual

INSTRUMENT CLUSTER
WATER TEMPERATURE SENDER UNIT
Removal I Installation
1. Disconnect the water temperature sender unit connec­
tor.
2. Remove the water temperature sender unit.
3. Before installing the unit, apply sealant from the third
thread to the top thread.
4. Install in the reverse order of removal.
Tightening torque: 11.8— 17.6 N-m
{120— 180 kgf cm, 105—156 in■ Ibf>
Inspection
1. Remove the water temperature sender unit.
2. Place the sensor in water.
3. Heat the water gradually and measure the resistance of
the sensor.
W ater temperature
Resistance
4. If not as specified, replace the water temperature
sender unit.

FUEL GAUGE SENDER UNIT

Inspection
1. Remove the fuel gauge sender unit.
(Refer to the 1996 626/MX-6 Workshop Manual, section
F1,F2 and F3.)
2. Measure the resistance between terminals D and C of
the fuel gauge sender unit while moving the unit arm
from point F to point E.
3. If not as specified, replace the fuel gauge sender unit.
C1
50 °C {122 °F}
Cl
189.4-—259.6
C 1-19