Table of Contents
Advertisement
Appendix E. Install a Hardware Management Console (HMC)
The Hardware Management Console (HMC) user interface provides the functions needed to create and
maintain a single or multiple-partitioned environment.
Note: This section refers to systems capable of running multiple partitions. The Model 6C3 and Model
6E3 cannot run multiple partitions. However, your system is considered a full system partition, and
a full system partition allows you to connect to an HMC and use programs such as Service Focal
Point and Inventory Scout Services. When one of the following procedures in this section asks you
to select a partition from a list of partitions, or to configure additional partitions, the only partition
that you are concerned with is the one you are working on.
Position the HMC and Monitor
Position the HMC and monitor at or near their desired location.
v The HMC weighs between 34 kg (75 pounds) and 41 kg (90 pounds). Do not try to lift the HMC by
yourself.
v Monitors can weigh as much as 35 kg (77 pounds). Use caution when lifting or moving the monitor.
v Leave enough space around the HMC to safely and easily complete the setup procedures.
v Observe standard ergonomic guidelines while arranging your system unit so that you can work
comfortably and safely. For more information on arranging your workstation, visit the Healthy Computing
Web address at: http://www.pc.ibm.com/us/healthycomputing.
v Be sure to maintain at least 51 mm (2 inches) of space on the sides of the system unit and 152 mm (6
inches) at the rear of the system unit to allow the system unit to cool properly. The front of the system
requires a minimum of 76 mm (3 inches) of space. Blocking the air vents can cause overheating, which
might result in a malfunction or permanent damage to the system unit.
v Place the HMC in a location where all necessary power outlets and network connections can safely be
reached.
v Place the display in a stable and sturdy location.
419
Advertisement
Table of Contents
