Table of Contents
Advertisement
7.
Before installing the system rail assemblies into your rack, you must first preset the rails to allow
correct assembly with the rack and system unit. Do the following:
a. Unpack the system rail assemblies.
b. Fully extend each rail assembly.
c. Lock the rear latch assemblies to the open position using the latch release tab.
1 Left rail assembly
2 Right rail assembly
3 Rail-mounting latch assembly, rear
8. Position yourself at the front of the rack.
9. Facing the rack, insert the rail's rear-alignment pins into the rack's rear flange holes identified by the
self-adhesive placement dots previously installed.
10. Press the release tab. This action will cause the rear latch assembly to close on the flange. Ensure
that the pins have passed through the proper holes in the rear flange to verify proper alignment.
11. Insert the rail's front-alignment pin into the rack front flange hole identified by the self-adhesive
placement dot previously installed. Ensure that the EIA location is the same from front to back and
the rails are level from front to rear.
12. Loosely thread one of the rail-retaining screws into the rail's front screw hole. The screw hole is
located one position above the front-alignment pin.
412
EserverpSeries 615 Service Guide
6
1
2
5
4 Rail-mounting latch assembly release
tab, rear
5 Rail-mounting hardware, front right
6 Cable-management arm flange
3
4
Advertisement
Table of Contents
