Table of Contents
Advertisement
1 Model 6E3
2 Optional SCSI Media Device
(Shown in Media Bay Chassis)
3 Media Bay Chassis
4 Optional SCSI Media Device
Screw (3)
SCSI Media Devices
A SCSI media device can be placed in the SCSI media-device bay. If a SCSI media device is installed in
the system, then a power cable and a SCSI cable will be connected to the rear of the SCSI media device
and routed to the appropriate connectors on the rear of the media-bay-chassis backplane or PCI adapter.
If the SCSI media device is connected to a audio card, then a cable will be connected to the rear of the
SCSI media device and routed through the system to the audio card. If the SCSI media device is a
DVD-RAM, then a single-ended cable will be connected to the rear of the DVD-RAM and routed through
the system to a single-ended (SE) SCSI adapter. See the illustration on page 330.
Removing a SCSI Media Device
To remove a SCSI media device, do the following:
1. Shut down the system as described in "Stopping the System" on page 282.
2. Disconnect the power source from the system.
Note: This system may be equipped with a second power supply. Before continuing with this
procedure, ensure that the power source to the system has been completely disconnected.
3. Place the system into the service position as described in "Placing the Model 6C3 into the Service
Position" on page 284 or "Placing the Model 6E3 into the Service and Operating Position" on page
286.
4. Remove the front bezel as described in "Bezels" on page 291.
5. Remove the media bay chassis as described in "Media Bay Chassis" on page 345.
Note: Look to see if any cables that are routed into the system are plugged into the connectors on the
media bay chassis. If present, unplug the cables.
328
EserverpSeries 615 Service Guide
1
5
5
4
3
2
4
7
8
5 Blue Retaining Tab (For Slimline Devices)
6 Front Bezel
7 Slimline Diskette or Optical Device
8 Slimline Optical Device
6
Advertisement
Table of Contents
