IBM P 615 series Service Manual page 166

Table 2. Firmware Checkpoints (continued)
Checkpoint
E1F6
E1F7
E1F8
E1F9
E1FA
E1FB
E1FC
E1FD
E1FE
E1FF
E20F
E440
146 EserverpSeries 615 Service Guide
Description
Determine boot device sequence
No boot image located
Building boot device list for SCSI adapters.
(The location of the SCSI adapter being
scanned is also displayed.)
Building boot device list for fibre-channel
adapters. (The location of the SAN adapter
being scanned is also displayed.)
Building boot device list for SCSI adapters.
(The device ID and the device LUN being
scanned are also displayed.)
Scan SCSI bus for attached device8
Building boot device list for SSA adapters.
(The location code of the SSA adapter
being scanned is also displayed.)
The operator panel alternates between the
code E1FD and another Exxx code, where
Exxx is the point at which the error
occurred.
Building boot device list for fibre-channel
adapters. (The WWPN of the SAN adapter
being scanned is also displayed.)
Building boot device list for fibre-channel
adapters. (The WWPN of the SAN adapter
being scanned is also displayed.)
System firmware has exited to open
firmware prompt
Validate NVRAM, initialize partitions as
needed
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 110.
Go to "Boot Problems/Concerns" on page
155.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 110.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 110.
Go to "MAP 1540: Problem Isolation
Procedures" on page 110.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 110.
Go to "MAP 1548: Processor Subsystem
Problem Isolation" on page 113.
1. If a location code is available, follow the
actions listed for error code 21A0 00xx.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 110.
1. If a location code is available, follow the
Repair actions listed for error code
21A0 00XX.
2. If no location code is available, go to
"MAP 1540: Problem Isolation
Procedures" on page 110.
Go to "MAP 1540: Problem Isolation
Procedures" on page 110.
1. Replace the service processor,
Location: U0.1-P1-X1.
2. Call service support.
1. Check for system firmware updates.
2. Replace the service processor,
Location: U0.1-P1-X1.
3. Call service support.