IBM P 615 series Service Manual page 185

Checkpoint or What You Should Do
Error Code
8xxx Service Processor Checkpoints
9xxx
Go to "Service Processor Checkpoints" on page 133 for more information on these checkpoints.
Axxx
Bxxx
A1FD 000x The system has entered recovery mode. Go to "Recovery Mode" on page 254.
B006 xxxx Common Firmware Error Codes
B1xx xxxx
1. There may be additional error codes and information in the service processor error log. The
system must be powered off to examine the contents of the service processor error log.
a. Is the system still powered on?
b. Can the system be powered off?
2. Confirm that this is the first error code that caused the failure as described in "Confirming Initial
Error Code" on page 159.
3. Did you come to this step from step 2?
NO
YES
B3xx xxxx HMC Surveillance Error Codes
Go to "HMC Surveillance Error Codes" on page 214 for more information on these error codes.
Exxx Firmware Checkpoints
Go to "Firmware Checkpoints" on page 140 for more information on these checkpoints.
Mxxx xxxx Problem Determination-Generated Error Codes
Go to "Problem Determination Generated Error Codes" on page 215 and follow the instructions in
the Problem Determination Generated Error Codes table.
NO Go to step 2 below.
YES Ask the customer if the system can be powered off, then go to step 1b below.
NO Go to step 3 below.
YES Power off the system, then go to step 2 below.
Go to "Common Firmware Error Codes" on page 200 with the error codes you already
have and follow the instructions in the "Common Firmware Error Codes" on page 200
table.
Go to "Common Firmware Error Codes" on page 200 with the error codes from 2 and
follow the instructions in the "Common Firmware Error Codes" on page 200 table.
Chapter 5. Error Code to FRU Index
165