Map 1549: Attention Problem Isolation - IBM P 615 series Service Manual

Step 1548-22
The adapter or device is probably defective.
If the supplemental media is for an adapter, replace the FRUs in the following order:
1. Adapter
2. CEC backplane (see notes on page 53)
If the supplemental media is for a device, replace the FRUs in the following order:
1. Device and any associated cables
2. The adapter to which the device is attached
Repeat this step until the defective FRU is identified or all the FRUs have been exchanged.
If the symptom did not change and all the FRUs have been exchanged, call service support for assistance.
If the symptom has changed, check for loose cards, cables, and obvious problems. If you do not find a
problem, go to the "Quick Entry MAP" on page 55 and follow the instructions for the new symptom.
Go to "MAP 0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for Multiple
Bus Systems.

MAP 1549: Attention Problem Isolation

Step 1549-1
Record the error code and the location code(s) that sent you to this MAP.
Step 1549-2
Turn off the power.
Step 1549-3
Examine the following table and locate the error code that sent you to this MAP to determine your next
step.
Error Code
406x 0EB1
406x 0EB2
406x 0EB3
406x 0EB4
406x 0EB5
406x 0EB6
406x 0EB7
406x 0EB8
406x 0EB9
406x 0EBA
406x 0EBB
406x 0EBC
Action
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Go to "Step 1549-7" on page 127.
Chapter 3. Maintenance Analysis Procedures (MAPs)
125