Table of Contents
Advertisement
The type of compass that will appear in the INFO display depends on
the internal dip switch settings in the Control Unit.
For details, refer to the Installation section, page 5-58.
To select another compass as MAIN Compass, press INCREASE or
DECREASE.
One of the same type of compasses listed as MAIN Compass may be
displayed.
To select another MONITOR COMPASS, press INCREASE or
DECREASE.
If a single compass is connected, no selection of compass can be
made.
No heading sensors are functioning (or connected).
Press ALARM RESET to cancel the audible alarm. The INFO display
will now show:
Only the NFU and FU steering levers can be used as Autopilot mode
is disabled.
For remote station only:
This warning applies only for the remote station in a DUAL
STATION system.
20169223D
• SERIAL COMP.
• SYNCHRO 1:1 GYRO
• SYNC 90:1 GYRO
• SYNC 360:1 GYRO
• STEPPER GYRO
• MAGN COMP 1
• MAGN COMP 2
• FLUXG COMP
2nd press
MONITOR COMP.
COMPASS
SELECT
- - - - - - - - - - - - -
COMPASS SELECT
COMPASS FAIL
USE HELMSMAN/NFU
COMPASS SELECT
ONLY ON MAIN CONT.
Press
FAIL
Operation
INCR EASE
or
DECREASE
2-27
Advertisement
Table of Contents
