F200-40 Remote Control - Simrad Robertson AP9 Mk3 Instruction Manual

F200-40 Remote Control

F200
COURSE
PORT STBD
MODE
If a separate external mode selector is used, this must include an off position
Note !
to enable mode changes from the F200-40 Remote Control. Refer to page 5-
23.
F200-40 Functions
The table starts with the autopilot switched to HELMSMAN mode
with 080° as heading.
20169223D
The F200-40 hand held remote control makes it possible to
remotely control the AP9 MK3 autopilot.
The following control functions are obtainable:
• Display that shows operational mode and vessel heading or set
course like the course display on the control unit.
• Course selection by a rotary knob
• Course adjustments by push buttons
• Mode selection
• Manual steering by course selector knob (Follow-Up)
• Manual steering by push buttons (Non-Follow-Up)
In a dual station system, using one main and one remote control
unit, it is possible to connect one F200-40 to each control unit and
obtain individual control from each unit.
F200-40
AP9MKII Display
Mode button
NON FOLLOW UP
HELMSMAN
Press F200-40
Mode button
one time
F200 FOLLOW UP
HELMSMAN
Press F200-40
Mode button a
second time
* * * * * * *
AUTOPILOT
Press F200-40
Mode button a
third time
Function F200-40 Display
NFU steering by
F200-40 PORT/
STBD push
Vessel heading
buttons.
Follow-Up steering
by F200-40
Course Selector
Midship rudder
button
4°port rudder
32° stbd rudder
Autosteering.
Course changes
can be made
Automode
either by the
146° Course to
F200-40 Course
steer
Selector, PORT
and STBD buttons
or, by the autopilot
Course Selector.
Operation
2-21