Basic Operation; Selecting Which Processor To Control; Turning The Unit On/Off; Positioning A Man Over Board Mark - Simrad NSO Operation Manual

2 Basic operation

Selecting which processor to control

Before an OP40 can be used it must be configured and assigned to the processor. Refer
to the separate NSO Installation manual for more information.
The following color codes are used on the OP40's DISPLAY LED;
DISPLAY
MOB
To take control of the next display press the DISPLAY key. Short presses of the DISPLAY
DISPLAY
MOB
key will toggle control through LED positions that have been assigned.

Turning the unit on/off

* On multiple processor systems the processor to power up must be selected prior to
pressing the PWR key.
There is 5 second delay before an image will appear on the screen.
If the radar is running you can turn it to standby mode from within the
Light dialog.

Positioning a Man Over Board mark

If an emergency situation should occur, you can position a Man Over Board waypoint at
the vessel's current position by pressing and holding the MOB key.
When you activate the MOB function the following actions are automatically performed:
-
a MOB waypoint is positioned at the vessel's position
-
the display switches to a zoomed Chart panel, centered on vessel position
-
the vessel starts navigating towards the MOB waypoint
Color/Status
Red
Green - Flashing
Green
POWER ON
1 * 2
DISPLAY
PWR
MOB
Description
Processor is OFF
Processor powering up
Processor is ON
STAND BY
PWR
POWER OFF
3 s
PWR
Basic operation | 11