TP-Link TL-SG2424 User Manual page 97

2 Enable STP function
3 Configure the region name and
the revision of MST region
4 Configure
mapping table of the MST region
The configuration procedure for switch E and F is the same with that for switch D.

The topology diagram of the two instances after the topology is stable

For Instance 1 (VLAN101, 103 and 105), the red paths in the following figure are connected

links; the gray paths are the blocked links.
For Instance 2 (VLAN102, 104 and 106), the blue paths in the following figure are connected

links; the gray paths are the blocked links.
be found in the section
On Spanning Tree→STP Config→STP Config
page, enable STP function and select MSTP version.
On Spanning Tree→STP Config→Port Config
page, enable MSTP function for the port.
On
Config page, configure the region as TP-LINK and
keep the default revision setting.
VLAN-to-Instance On Spanning Tree→MSTP Instance→Instance
Config page, configure VLAN-to-Instance mapping
table. Map VLAN101, 103 and 105 to Instance 1; map
VLAN102, 104 and 106 to Instance 2.
802.1Q
Spanning Tree→MSTP
89
VLAN.
Instance→Region