Basic Config; Global Config - TP-Link TL-SG2424 User Manual

The LLDP module is mainly for LLDP function configuration of the switch, including three
submenus: Basic Config, Device Info, Device Statistics and LLDP-MED.

13.1 Basic Config

LLDP is configured on the Global Config and Port Config pages.

13.1.1 Global Config

On this page you can configure the LLDP parameters of the device globally.
Choose the menu LLDP→Basic Config→Global Config to load the following page.
The following entries are displayed on this screen
Global Config

LLDP:
Parameters Config

Transmit Interval:
Hold Multiplier:
Transmit Delay:
Reinit Delay:
Notification Interval:
Figure 13-1 LLDP Global Configuration
:
Enable/disable LLDP function globally.
Enter the interval for the local device to transmit LLDPDU to its
neighbors. The default value is 30.
Enter a multiplier on the Transmit Interval. It determines the actual
TTL (Time To Live) value used in an LLDPDU. TTL = Hold
Multiplier * Transmit Interval. The default value is 4.
Enter a value from 1 to 8192 in seconds to specify the time for the
local device to transmit LLDPDU to its neighbors after changes
occur so as to prevent LLDPDU being sent frequently. The default
value is 2.
This parameter indicates the amount of delay from when LLDP
status becomes "disable" until re-initialization will be attempted.
The default value is 3.
Specify the interval of Trap message which will be sent from local
device to network management system. The default value is 5.
172