Packet Statistics - TP-Link TL-SG2424 User Manual

Choose the menu Multicast→MLD Snooping→Querier Config to load the following page.
The following entries are displayed on this screen:
Querier Config

VLAN ID:
Maximum Response
Time:
Query Interval:
Query Source IP:
Querier List

Select:
VLAN ID:
Maximum Response
Time:
Query Interval:
Query Source IP:
Note:
The MLD Snooping Querier doesn't participate in the MLD Querier Election, but an MLD Snooping
Querier will affect the MLD Querier Election in the IPv6 network running MLD because of its
relatively smaller IP address.

8.2.7 Packet Statistics

On this page you can view the MLD packets the switch received. It helps you to monitor the MLD
Snooping function.
Figure 8-17 Querier Config
Enter the VLAN ID which you want to start Querier.
Enter the value of Maximum Response Time field of
the Query message.
Enter the Query message interval time. The Querier
will send General Query Message with this interval.
Enter the Query Message source IP address. It is
FE80::02FF:FFFF:FE00:0001 by default.
Select the Querier you want to change.
Displays the VLAN ID.
Displays the value of Maximum Response Time field
of the Query message.
Displays the Query message interval time.
Displays the Query message source IP address.
115