Rmon - TP-Link TL-SG2424 User Manual

Type:
Retry:
Timeout:
Notification Table

Select:
IP Address:
UDP Port:
User:
Security Model:
Security Level:
Type:
Timeout:
Retry:
Operation:

12.3 RMON

RMON (Remote Monitoring) based on SNMP (Simple Network Management Protocol)
architecture, functions to monitor the network. RMON is currently a commonly used network
management standard defined by Internet Engineering Task Force (IETF), which is mainly used to
monitor the data traffic across a network segment or even the entire network so as to enable the
network administrator to take the protection measures in time to avoid any network malfunction. In
addition, RMON MIB records network statistics information of network performance and
malfunction periodically, based on which the management station can monitor network at any time
effectively. RMON is helpful for network administrator to manage the large-scale network since it
reduces the communication traffic between management station and managed agent.
RMON Group

This switch supports the following four RMON Groups defined on the RMON standard (RFC1757):
History Group, Event Group, Statistic Group and Alarm Group.
Select the type for the notifications.

Trap: Indicates traps are sent.

Inform: Indicates informs are sent. The Inform type has a
higher security than the Trap type.
Specify the amount of times the switch resends an inform
request. The switch will resend the inform request if it doesn't
get the response from the management station during the
Timeout interval, and it will terminate resending the inform
request if the resending times reach the specified Retry times.
Specify the maximum time for the switch to wait for the
response from the management station before resending a
request.
Select the desired entry to delete the corresponding
management station.
Displays the IP Address of the management host.
Displays the UDP port used to send notifications.
Displays the User name of the management station.
Displays the Security Model of the management station.
Displays the Security Level for the SNMP v3 User.
Displays the type of the notifications.
Displays the maximum time for the switch to wait for the
response from the management station before resending a
request.
Displays the amount of times the switch resends an inform
request.
Click the Edit button to modify the corresponding entry and
click the Modify button to apply.
163