TP-Link TL-SG2424 User Manual page 26

Choose the menu System→System Info→System IP to load the following page.
The following entries are displayed on this screen:
IP Config

MAC Address:
IP Address Mode:
Management VLAN:
IP Address:
Subnet Mask:
Default Gateway:
Note:
1. Changing the IP address to a different IP segment will interrupt the network communication, so
please keep the new IP address in the same IP segment with the local network.
2. The switch only possesses one IP address. The IP address configured will replace the original
IP address.
3. If the switch gets the IP address from DHCP server, you can see the configuration of the
switch in the DHCP server; if DHCP option is selected but no DHCP server exists in the
network, a few minutes later, the switch will restore the setting to the default.
Figure 4-7 System IP
Displays MAC Address of the switch.
Select the mode to obtain IP Address for the switch.
Static IP: When this option is selected, you should enter IP

Address, Subnet Mask and Default Gateway manually.
DHCP: When this option is selected, the switch will obtain

network parameters from the DHCP Server.
BOOTP: When this option is selected, the switch will obtain

network parameters from the BOOTP Server.
Enter the ID of management VLAN, the only VLAN through which
you can get access to the switch. By default VLAN1 owning all the
ports is the Management VLAN and you can access the switch via
any port on the switch. However, if another VLAN is created and
set to be the Management VLAN, you may have to reconnect the
management station to a port that is a member of the
Management VLAN.
Enter the system IP of the switch. The default system IP is
192.168.0.1 and you can change it appropriate to your needs.
Enter the subnet mask of the switch.
Enter the default gateway of the switch.
18