System Ip - TP-Link TL-SG2424 User Manual

The following entries are displayed on this screen:
DST Config

DST Status:
Predefined Mode:
Recurring Mode:
Date Mode:
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of European in predefined mode.

4.1.5 System IP

Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.
Enable or disable the DST.
Select a predefined DST configuration.
USA: Second Sunday in March, 02:00 ~ First Sunday in

November, 02:00.
Australia: First Sunday in October, 02:00 ~ First Sunday in

April, 03:00.
Europe: Last Sunday in March, 01:00 ~ Last Sunday in

October, 01:00.
New Zealand: Last Sunday in September, 02:00 ~ First

Sunday in April, 03:00.
Specify the DST configuration in recurring mode. This
configuration is recurring in use.
Offset: Specify the time adding in minutes when Daylight

Saving Time comes.
Start/End Time: Select starting time and ending time of

Daylight Saving Time.
Specify the DST configuration in Date mode. This configuration is
recurring in use.
Offset: Specify the time adding in minutes when Daylight

Saving Time comes.
Start/End Time: Select starting time and ending time of

Daylight Saving Time.
17