Connecting An Emergency Signal; Using The Interactive Menu; Overview; Navigate Through The Menu - Shure DCS 6000 User Manual

DIS Digital Conference System
To use the emergency signal function, a switch
6.3.11

Connecting an emergency signal

(normally-open) must be connected to the
emergency switch connector. When the switch is
closed an "Emergency Evacuation Message
(EEM)" audio signal present on the 'In 2' input is
6.4

Using the Interactive Menu

The major configurations and operation options
6.4.1

Overview

of the CU 6110 can be set via an interactive
menu, using the 2x20 character OLED display
and the 5-button keypad.
'Figure 5.3 A' gives an overview of the menu
structure, however for a general description of
the settings in the menu refer to the section '6.5
Web Browser Setup and Control' where all CU
6110 settings are explained.
Figure 6.4-A Menu overview
distributed to all output channels, overriding all
other audio inputs.
Important: The level of the signal must be controlled
externally.
Navigation
6.4.2
parameters is done by activation the 5-button
keypad:



Press the 'Enter' button in the center to accept
the value. Pressing the Enter button concludes
the selection made, and at the same time it
indicates a confirmation of the possible changes
made within the selection.
Please note that some changes are applied
immediately but might not be saved. Saving of
those settings to the memory of the CU 6110 will
be done within 15-30 seconds.
User Manual CU 6110 rev A.docx
in the menu

Navigate through the menu

Cycle through the menu items (Blue
marking) with the four 'arrow' buttons (Left-
Right, Up-Down).
Navigate to a settable option (Green
marking).
Cycle through the available values for a
settable option using the 'arrow' buttons Up-
Down.
User Manual
and changing
25