Troubleshooting - Strong SRT 82 User Manual

Subtitle FontColor
PVR Configure
Record Device
Timeshift Size
NOTE:
Format
WARNING:
If you have multiple partitions on your storage device, select the partition you would like to format
and press OK to continue. A confirmation banner will now be displayed. Press OK to start formatting
(or EXIT to cancel it). The format procedure will take some time, depending on the size of the used
storage device. At the end of the process, the "Formatting is complete" message will appear. Press
EXIT twice to exit the menu.

8.0 TROUBLESHOOTING

There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem
The LED/standby
indicator and LED
display (if available on
your receiver) are not
switching on.
The external IR sensor is
not working
16
Select the preferred colour of the Subtitle characters.
For this option to work, you must have a USB device connected.
If your USB device should have more than 1 partition, select the one to use.
Select the amount of free space, to be assigned to the Timeshift function.
Default is 1GB, which would account for around 1 hour of video, depending
on the video format and resolution.
Below this setting information is shown about the current partition or
device.
The use of a USB Hard Disk Drive, already formatted in a PC with FAT32 or
NTFS is recommended.
The format function will delete all data and information from your USB
device or selected partition. Manufacturer will not take any responsibility
for damaged or lost data on the USB device.
Possible cause
The power cable or power
adapter is unplugged.
If your receiver has a main power
switch: The main power switch on
the rear panel is set to OFF.
The external IR sensor is not
working.
The electrical outlet may be
damaged.
What to do
Check that the power cable or
power adapter is plugged to the
wall outlet.
Switch the main power on.
Check if the external IR sensor is
(properly) connected.
Check with another device if the
electrical outlet is supplied.