Connecting Audio Input; Using A Microphone; Connecting Line Input Audio Equipment - Sony SRW-9000 Operation Manual

Connecting Audio Input

Using a Microphone

You can attach a microphone to the viewfinder
(when the viewfinder has a microphone holder),
to the top panel of the main unit, or to the handle.
To attach a microphone to the top panel of the
main unit or to the handle, first attach the optional
CAC-12 Microphone Holder.
Remove the two microphone attachment screws
on the top panel of the main unit, or remove the
two screws on the left side of the handle, and then
attach the CAC-12.
To attach the CAC-12 to the top panel of
the main unit
Microphone attachment screws
CAC-12 Microphone Holder (optional)
To attach the CAC-12 to the handle
Screws
CAC-12 Microphone Holder (optional)
Handle
To connect a microphone
Mount the microphone in the microphone holder,
connect the microphone cable to the AUDIO IN
CH-1 or CH-2 connector, and set the
corresponding input selection switch to "MIC" or
"MIC +48V".
2
1 Microphone
2 To AUDIO IN CH-1 or CH-2 connector
For details on how to attach a microphone to the
microphone holder, refer to the operation manual for
the microphone.
Notes
• If the input level on this unit is not at an appropriate
setting for the microphone sensitivity, loud sounds
may be distorted, and the signal-to-noise ratio may be
affected.
• The AUDIO IN CH-1 and CH-2 connectors are female
XLR connectors (3-pin), to enable them to provide a
phantom 48 V power supply. If the microphone cable
has a female connector, use a conversion adaptor.
• When you detach the CAC-12 Microphone Holder,
save the screws that you used to attach it and screw
them back into the original screw holes.
Connecting Line Input Audio
Equipment
Connect the audio output connector of the line
input signal source equipment to the AUDIO IN
CH-1 or CH-2 connector, and set the
corresponding input selection switch to "LINE".
Connecting Audio Input
1
33