Outputting Rec Trigger Signals - Sony SRW-9000 Operation Manual

Item Selectable color-bar formats
SD-BAR SMPTE, EIA, FULL (EBU), 95%,
NTSC100% (PAL100%)
Note
The color bar signal is not output with the video output
from the VF, HD SDI MON1, HD SDI MON2, and
REMOTE connectors if the monitor LUT (R709) is
selected for MLUT/PBMIX of the respective output on
the <PB/MON LUT> page (see page 131) (except when
a VBS signal is output).

Outputting Rec Trigger Signals

By outputting Rec Trigger signals to an SRW-1/
SRPC-1 connected to the HD SDI MON1 or HD
SDI MON2 connector or the HD SDI OUT A/B
connector (when the HKSR-9001 is installed),
you can configure a function that enables
recording in conjunction with the unit.
Use the <OTHERS 1> page of the Camera
>USER (MAINTENANCE) menu.
Unit status SDI REMOTE
setting
Not recording CHAR
G-TLY
R-TLY
Recording CHAR
G-TLY
R-TLY
60 Setting the Camera Outputs
<OTHERS 1> page
Notes
• Even if there is no cassette loaded in the unit or the tape
ends, Rec Trigger signals will be output when you
press the REC button (or RUN button).
• If the tape ends or the cassette is removed while Rec
Trigger signals are being output, tape recording will
start when you load a new cassette and press the REC
button (or RUN button).
Set SDI REMOTE to CHAR, G-TLY, or R-TLY.
Depending on the status of the unit, the
viewfinder, unit tally indicator, and control panel
displays will be as follows.
SDI REMOTE Display
output status
REC • Viewfinder: "REC2" flashes on the screen.
• Control panel: The "O" for SDI RMT is displayed in red.
STOP • Control panel: The "O" for SDI RMT is displayed in
white.
REC • Viewfinder: The green tally lights.
• Unit tally indicator: Lights in green.
• Control panel: The "O" for SDI RMT is displayed in red.
• Control panel: The "O" for SDI RMT is displayed in
STOP
white.
REC • Viewfinder: The red tally lights.
• Unit tally indicator: Lights in red.
• Control panel: The "O" for SDI RMT is displayed in red.
STOP • Control panel: The "O" for SDI RMT is displayed in
white.
REC • Viewfinder: "REC2" flashes on the screen. The red tally
lights.
• Control panel: The "O" for SDI RMT is displayed in red.
REC • Viewfinder: The green tally lights. The red tally lights.
• Unit tally indicator: Lights in red. Lights in green once
every 4 seconds.
• Control panel: The "O" for SDI RMT is displayed in red.
REC • Viewfinder: The red tally lights.
• Unit tally indicator: Lights in red.
• Control panel: The "O" for SDI RMT is displayed in red.